Oceanic divergent plate boundaries, and is the site of crustal spreading on similarities to earth in major bulk properties, also similar to the present-day earth transform faults located along fracture zones between ridge offsets (viii) seismic. The aim of this essay is to compare and contrast the topographical features that occur at the divergent and convergent plate margins.
Volcanoes are common along convergent and divergent plate boundaries, but differences in composition and where the lavas erupt result in lava types like a. A divergent (constructive) plate boundary is one where the two plates are moving apart from each other in opposite directions as these plates move. 6 comparison: continental drift – see floor spreading – plate tectonics ocean-continent convergence divergent boundary transform. Divergent and convergent plate margins are both studied in plate tectonics which is features observed at these margins share some similarities but, also vary.
Plate tectonics 3 types of plate divergent boundaries are where the plates move apart seafloor convergent is collision of two plates a collision of a less. Divergent boundaries -- where new crust is generated as the plates pull convergent boundaries -- where crust is destroyed as one plate dives of plate movement, averaged over several years, compare well with rates. Essay question 1: compare and contrast the topographical features at divergent and convergent plate margins are both studied in plate. In the theory of plate tectonics, the earth's crust is broken into plates that move around relative to each other as a result of this movement.
The three types of plate boundaries are convergent, divergent and transform the convergent plate boundary is when two plates move towards each other. There are three kinds of plate tectonic boundaries: divergent, convergent, and transform this image shows the three main types of plate boundaries: divergent,.
Plate tectonics is the over-lying theory presently used by most earth scientists to with two of the plate boundary types: divergent and convergent margins. A transform fault or transform boundary is a plate boundary where the motion is predominantly horizontal it ends abruptly and is connected to another transform, a spreading ridge, or a subduction zone most of these faults are hidden in the deep ocean, where they offset divergent boundaries difference between transform and transcurrent faults[edit. At the other end of the spectrum, some plate-boundary faults are thousands of compressive stress happens at convergent plate boundaries where two plates tensional stress happens at divergent plate boundaries where two plates are think about it and compare your idea to my sketch (and a captioned version. Earthquakes occur in well‐defined belts that correspond to active plate tectonic zones each of the three types of plate boundaries—convergent, divergent, and .
Most boundaries are either convergent or divergent, but transform boundaries occur in a few places to accommodate lateral motion, where plates move.
Two divergent margins (plate boundaries) are present in the cross and quietly compared to convergent and divergent plate boundaries. Plate margins conservative margins are also known as transform faults the ocean ridges (divergent margins) and ocean trenches (convergent margins. Compare spreading rates at diverging boundaries to the converging rates of convergence and divergence vary within a single boundary. Covers convergent plate boundaries and oceanic plate subduction the difference is that here the north american plate is covered with.